Damper / Solutions

solution

Full‑cycle engineering closed‑loop: risk identification, custom damping, monitoring & maintenance.

Solution path

Risk‑Identification‑Custom‑Damping‑Monitoring‑O&M Closed‑Loop

01

Risk identification & assessment

Gather structural & condition data; modal, wind‑vibration, strength and fatigue analysis for cross‑wind‑resonance risk evaluation.

02

Custom TMD damping

Tune mass, stiffness, damping & stroke for target frequency and site constraints, including fabrication and field commissioning.

03

Monitoring & intelligent O&M

Vibration‑data acquisition, effect validation, anomaly alert and maintenance support.

Service object

Applicable to slender tall equipment of low stiffness & low damping

Reconstruction‑and‑Capacity‑expansion‑Condition‑Review

Changes in medium, internals, platforms or working conditions may alter structural dynamic characteristics and require re-evaluation.

Vibration control of in-service equipment

Assessment & mitigation for sustained shaking, abnormal noise and connection damage.

Design optimization of new equipment

Design‑stage‑Cross‑wind‑Resonance‑Fatigue‑Assessment‑&‑Scheme‑Reservation

Project deliverables

Deliver more than equipment: verifiable engineering outcomes.

✓
Calculation & Evaluation Report Design input, model, key parameters, risk conclusions and suggestions.
✓
Custom Products & Engineering Drawings Device structure, interface, material, installation and maintenance requirements.
✓
On-site Commissioning & Verification Installation guidance, parameter confirmation, commissioning and data comparison before and after treatment.

OK